Blown In Attic Insulation in ALBUQUERQUE

CELLULOSE

Cellulose consists of fibers made from recycled newspaper, cardboard, or wood and is made with or without binders. Cellulose is a very common type of blown-in insulation as it is made from recycled materials and is chemically treated to resist pests, mold, and fire. Boric acid is the primary chemical used to treat Cellulose insulation and is found naturally in seawater, fruits, and plants.

FIBERGLASS

Fiberglass is made from plastic, glass, and other raw materials that are melted and spun into fibers that resemble the texture of wool. Fiberglass insulation has moisture and fire-resistant properties. Because fiberglass is made from sand and glass, it is naturally non-combustible. Fiberglass has significant recycled content with some loose-fill products containing up to 80% recycled glass.

Energy-efficient

Increasing the R-value of your insulation may help you to money on energy bills and maximize the energy efficiency of your home. Blown-in insulation is a environmentally conscious, cost effective way to increase your attic’s insulation, which in turn may help lower your cooling and heating bills. For maximum energy efficiency, we recommend a powerful combination of insulation and proper air sealing. This can help eliminate air leaks that pass through recessed light fixtures, plumbing areas, and duct work.

Blown-in insulation slows heat transfer from your attic to the lower levels of your home during the hot summer and works hard to keep the warm air inside your home during the cold winter months. The attic is the main location where heat enters and exits the home, making it difficult to keep your home temperatures consistent. Proper insulation can target reducing heat transfer while also allowing your HVAC system to increase its performance.

Environmentally Friendly

One of the many positive benefits Blown-in insulation has is that it is environmentally friendly. Not only does it improve the energy efficiency of your home, but it also helps protect the environment.

Cellulose is made up of 80% recycled materials, with the remaining consisting of non-toxic borate solution. This solution gives the insulation a Class-1 fire safety rating and makes it mold and pest resistant. Certain fiberglass products can contain up to 80% recycled glass products and is non-combustible.

Blown-in insulation not only protects your home from energy loss, butal so helps reduce emissions associated with heating and cooling equipment. For those home owners who are looking for economical ways to reduce their environmental impact, curb energy waste, and increase the comfort of your home, blown-in insulation may be the solution for you!

Blown-in insulation provides a dense, effective barrier against heating/cooling loss or gain, and it provides an affordable R-value per inch. “R” means resistance to heat flow. The higher the R-value, the greater the insulating power.

Dense-packed cellulose or fiberglass insulation blocks the bulk of air movement and has a higher R-value per inch than insulation installed at a lower density. Attics can accommodate a deep layer of insulation, as much as 16 to 26 inches, making the resistance to heat flow even higher by installing blown-in insulation.

Fiberglass blown-in insulation is a loose material which allows the installation amount to be customized according to your local energy efficiency recommendations. Depending on which climate zone you live in, you may need a higher R-value. The higher the R-value, the more it will decrease air flow and help you conserve energy.

When it comes to insulating your home, R-value matters.